SOLAR PUMPS   SOLAR PUMPS 301 West 12th Street l Elk City, Oklahoma  73644 Toll Free:  1-866-246-7652 l Phone:  1-580-225-1704 l Fax:   1-580-225-1120 Home Page  -  Products  -  Contact Us  -  Why Go Solar?  -  Testimonials  -  Typical Installations  -  MAP

Lorentz PS600 & PS200 Battery System Sizing Chart

Lorentz Battery Powered Pressure System Installation Diagram

Lorentz Battery System Wiring Diagram

LORENTZ PUMPS FOR BATTERY OPERATIONS

If the home already has a battery bank that is close enough to the well to avoid excessive voltage drops due to long wire runs,  the pump system can be powered by the existing battery bank. A load analysis should be done before adding a pump system to home power systems to make sure that the batteries, solar array or other generating source can produce enough power.  In most home pressurizing systems the pump only operates for an hour or less per day so the pump system is a very small addition to the household loads.

Lorentz pump systems are available for operation from a 24 volt or 48 volt battery bank.

If you are planning to operate a Lorentz pump in a pressure tank configuration, please keep in mind that the pump sees pressure as additional water lift requirement in a ratio of 2.31 to 1.  In other words, if you are going to operate a pressure system at 50 psi the pump will require an additional (2.31 X 50)115.5 feet of lift capability to accommodate the additional pressure.  This additional lift must be added to the total vertical lift required by the system in order to choose the correct pump system. from the selection chart.

Call 1-866-246-7652 for current prices or more information about Lorentz Solar Pumps